hoping you guys can help me with this cause i feel like i just wasted $160
so yea i ordered an lc-1 off of ebay and ended up with the new lc-2..
so im like whatever it's suppose to be better...i guess
ok so i hooked the power wires up to the switched 12v cig lighter
and the grounds to the cig lighter ground.
i also put in a 5a fuse instead of the original 10a in the fuse box as stated in the instructions.
i've calibrated it 4 times already and have done everything in the book.
the issue is that it stays at 24 which for the analog out1 0v is 7.4afr and 5v is 24afr..
no i couldn't get it to do anything yesterday after calibrating it 3 times
so today i doubled check my wiring and made sure i had 12v at the battery and then re-calibrated it.
now it stays at 24 unless unless im at WOT and under very heavy load
at around 5-6k i was getting readings of like 10.5-11 it happened so fast i barely seen the values but it seems to be working sorta
i have to really rev the motor like towards redline just to get any readings at all
could it be a pinhole leak in my welds?
faulty sensor?
the lc-2 is giving me no error codes.
i don't have serial port on my laptop so i can't change the settings in how it reads afr's