I just swapped my cherry turbo strut tower brace for an OMP one that I had to see if it felt any different. The car feels a good bit tighter than it was. But, I have a question about whaat I had to do when installing it.
The brace is technically for an 850, not a x70 series. OMP says it fits and it does. But, the ends do not fit flat on the top of the strut towers before it si tightened down. They get forced down and twists a bit when it is tightened.
Is this a problem? Will it mess up alignment or the angle of the towers or anything with this stress on it?
Maybe I am just over thinking it...